banner

Attic Ventilation Installation Lakeville MN

This page provides useful content and local businesses that can help with your search for Attic Ventilation Installation. You will find helpful, informative articles about Attic Ventilation Installation, including "Attic Ventilation Questions and Answers". You will also find local businesses that provide the products or services that you are looking for. Please scroll down to find the local resources in Lakeville, MN that will answer all of your questions about Attic Ventilation Installation.

Clean Air Innovations
(952) 997-3808
17428 Hazel CT Lakeville
Lakeville, MN
 
Prosperity Living Inc
(952) 447-8377
4655 Pleasant St SE Prior Lake
Prior Lake, MN
 
N Genius Ideas/Products
(651) 454-7221
1766 Nokia Way Eagan
Eagan, MN
 
Mondale Associates Inc
(952) 888-1770
8898 Wentworth Ave S Minneapolis
Minneapolis, MN
 
Rent A Vent
(651) 405-8500
3010 Lunar Ln Saint Paul
Saint Paul, MN
 
Advanced Air Systems SBS
(952) 432-9070
13822 Gladiola Way St Paul
St Paul, MN
 
C Shaw Inc
(952) 435-7585
17247 Horizon Trl SE Prior Lake
Prior Lake, MN
 
Jeppesen Air
(612) 964-2664
P.O. Box 406
Rosemount, MN

Data Provided By:
Breatheclean
(952) 703-8962
9555 James Ave S # 220 Minneapolis
Minneapolis, MN
 
Door Systems Distributors
(952) 472-2774
6411 Logan Ave S Minneapolis
Minneapolis, MN
 
Data Provided By:

Attic Ventilation Questions and Answers

Attic Ventilation Requirements

What is the proper ratio of ventilation per square foot of roof?


1.5 in per sq. ft. Just make sure that the ventilation is installed so an airway is formed to remove heat through the highest part from the lowest part. Ridge vents and soffit vents work best for this. Also, it is better to have ventilation the entire roof length rather than the 8x12 square vents occasionally in the soffit.

I can't say if it's cost efficient or not, but my attic fan cools the attic a lot. When it's in the 70s outside and the attic fan has not run at all, the attic is too hot to go in. On hot days (80+) it comes on in the early afternoon and runs until about 6:00pm. When it's running I can go into the attic without any problem and it's much cooler.

Another Answer:

The ventilation ratios go according to attic floor size not roof size. You can go as low as 1/300 of the attic floor area (for attics which have a continuous vapor barrier below) to a high of 1.5 in inches x the floor area in feet. So a 1000 sq. feet of attic floor area would require between 480 sq. inches to 1500 sq. inches. That is a huge difference in allowance. I would go with the higher number.
One other thing.. the best system uses ridge vents and soffit vents skipping gable end vents entirely. The number would be split about 50-50 between soffits and ridge.



...

Click here to read the rest of this article from Handyman