Drywall Repair Tualatin OR

This page provides useful content and local businesses that can help with your search for Drywall Repair. You will find helpful, informative articles about Drywall Repair, including "Drywall Repair Questions and Answers". You will also find local businesses that provide the products or services that you are looking for. Please scroll down to find the local resources in Tualatin, OR that will answer all of your questions about Drywall Repair.

Oswego Drywall Installers Inc
(503) 639-8694
14865 Sw 72nd Ave
Portland, OR
super drywall
(503) 484-3977
po box 6673
aloha, OR
Drywall Specialties of Oregon
(503) 245-1456
2307 Sw Beaverton Hillsdale Hwy
Portland, OR
Mudpuppy Construction & Drywall Inc
(503) 723-9477
5514 Se Henderson St
Portland, OR
Columbia Drywall Systems Incorporated
(503) 253-2970
9331 Ne Colfax St
Portland, OR
Delta Drywall
(503) 684-9464
7130 Sw Fir Loop
Portland, OR
Beare Be Enterprises Incorporated
(503) 652-8841
5699 Se International Way
Portland, OR
Anthony Richard Hentkowski
(503) 504-8968
3322 Se 39th Ave
Portland, OR
Good Guys Drywall & Remodeling
(503) 762-5135
3440 Se 143rd Ave
Portland, OR
Alejandro Ruiz Gallardo
(503) 502-0919
100 Se 160th Ave
Portland, OR

Drywall Repair Questions and Answers

Nail Pops

Nail Pops

We built a house 4 yrs ago. Over the past few months I have noticed approx. 10 nail pops in the drywall. What is the proper way to repair this?

They are caused by the studs behind the drywall shrinking. This leaves more nail (or screw) exposed and if you push on the drywall, and it moves back against the stud, it will force the head out through the joint compound. sometimes this will happen even if you don't push on the wall.

So it occurs to me. This is a new idea. But before you fix just the few you have now, if you are going to work on a wall... push it in hard all over the studs to get as many to pop as possible and fix them all at once.

To fix them, pick away the loose compound to expose the head. If it is a screw, (screws are often used now) screw it in tight. You don't want to screw it in through the surface of the drywall, you just want it dimpled. If it is a nail, same thing, drive it in, again not too deep.

Then using ready mixed joint compound refill and cover the hole. Sand it flush and flat and even with the surrounding wall, and repaint it. When you sand, use a sanding block. (A flat piece of wood you wrap the sandpaper around... preferably with some felt or rubber glued to the flat surface.) The sanding block will ensure you are sanding the area flat.

Stud nails coming out of wall through plaster

In several different areas of our three story townhome, it looks like the nails in the studs are coming out. There are round holes in the plaster that are spaced evenly apart vertically. In some areas, it looks like these were patched over previously to hide the nail head. What is going on?

What happens is the studs shrink behind the wallboard leaving a gap and then the wallboard is pushed in or pulled in by other screws or nails, the ones with the gap pop through. They are evenly spaced because the wall is screwed in every 8 inches or ...

Click here to read the rest of this article from Handyman