Electricians Claremore OK

This page provides useful content and local businesses that can help with your search for Electricians. You will find helpful, informative articles about Electricians, including "Wiring a 3-way or 4-way switch". You will also find local businesses that provide the products or services that you are looking for. Please scroll down to find the local resources in Claremore, OK that will answer all of your questions about Electricians.

K & B Electric
(918) 266-8895
Catoosa, OK
Electronic Equipment & Supplies Service & Repair, Electric Contractors, Lighting Fixtures Repair Maintenance & Installation
Residential & Commercial

Bradshaw Electric
(918) 341-4536
Claremore, OK
Lloyd's Electric
(918) 341-4436
Claremore, OK
Crossroads Electric & Controls
(918) 266-6046
Claremore, OK
Red Simpson Inc
(918) 266-7107
1800 South Cherokee Street
Catoosa, OK
Murray Electric Inc
(918) 835-9605
7508 E 11Th Street
Tulsa, OK

Data Provided By:
Electrical Odd Jobbers
(918) 342-2462
Claremore, OK
A Anderson Electric Inc
(918) 343-8766
1720 North J M Davis Boulevard
Claremore, OK
Sooner Electrical Services
(918) 266-5707
8215 East Hope Place
Catoosa, OK
Green Country Electric
(918) 266-3800
107 West Oak Street
Catoosa, OK
Data Provided By:

Wiring a 3-way or 4-way switch

Do you need to wire 2 switches to control the same light or lights??

Or, wire 3 switches to control the same light or lights??

Here are the instructions for wiring:

Wiring a 3-Way Switch

To use 2 switches to control the same fixture, you will need to use two 3-way switches.

Run 2-wire cable from the fixture to the first switch. Between the switches you will need to run 3-wire (with ground) cable. (The white and red wires will be the switched wires.)

In the picture below, we show power coming into the light fixture. The black (hot) wire will pass right through going to the first switch. Attach it to the white wire of the wire running to the switch. The white wire from the power source will attach to the light's white wire. The light's black wire should be attached to the black wire running to the first switch.

At the switch the white wire (hot) coming from the light, will be connected to the dark colored screw. Mark it with a black marker or paint the end black to indicate it is hot. The red and white wire of the 3-wire going to the next switch should be attached to the light colored screws. Connect the black wire of the 3 wire cable to the black coming into the switch from the light.

At the second switch, attach the black wire to the dark screw and the white and red to the light colored screws.
3 way switch wiring 3 way elementary
For more elementary wiring diagrams of different 3 way circuits scroll down to the bottom of the page. ...

Click here to read the rest of this article from Handyman