banner

Floor Heating Systems Installation Ashburn VA

This page provides relevant content and local businesses that can help with your search for information on Floor Heating Systems Installation. You will find informative articles about Floor Heating Systems Installation, including "Electric Radiant Floors". Below you will also find local businesses that may provide the products or services you are looking for. Please scroll down to find the local resources in Ashburn, VA that can help answer your questions about Floor Heating Systems Installation.

Modern Mechanical LLC
(571) 291-3338
21750 Red Rum Drive
Ashburn , VA
 
M E Flow Inc
(703) 777-2311
12 Cardinal Park Dr SE
Leesburg , VA
 
Vernon Heating & Air Cond Inc
(703) 968-7700
15100 Enterprise Ct Suite 200
Chantilly , VA
 
Airflow Systems Inc
(434) 979-4328
1713 Allied St
Charlottesville , VA
 
Air-Right Energy Design Inc
(703) 530-0166
12167 Livingston Rd
Manassas , VA
 
B & B A/C Htg Svc Co Inc-Sterling
(703) 450-2000
22570 Glenn Dr Suite 7
Sterling , VA
 
Jones-Rogers Inc
(703) 378-3200
14522A Lee Rd
Chantilly , VA
 
Tom Muse Service Company Inc
(703) 442-4848
8474 Tyco Rd Suite A
Vienna , VA
 
Hava Tech
(703) 899-0047
11021 Braddock Rd
Fairfax , VA
 
FH Furr Plbg Htg & A/C Inc
(703) 491-1234
9040 Mike Garcia Dr
Manassas , VA
 

Electric Radiant Floors

You want to look for a product that can be installed in a single layer of thinset cement rather than two layers. This is faster and easier. You also want to find a product where the fiberglass (or other supporting material) forms an umbrella protection over the resistance wire so that your trowel can glide over the fiberglass net without risk of nicking the wire. Some products weave their wire over-and-under a fiberglass net. In that case the resistance wire will always appear on the surface and you face a greater risk of nicking the cable with your trowel ·Thickness of the cold-lead wires that connect the heating rolls to the thermostat: You want the thinnest cold-lead wires available (1/8" thick), so you can easily cover them with thinset cement like the heat resistance wire. If the cold-lead wires are thicker you will need to chisel a grove in the cement slab, or use a circular saw to cut a groove in the plywood sub-floor or backer board to maintain the floor level flat.

· Length of the cold-lead wires: You want cold lead wires that are long enough to connect to the thermostat without additional cut-&-turns of the roll to bring the roll closer to the thermostat.

·Vendor Technical Support Look for a vendor who will design an installation layout customized to your own floor plan. Understand that the heat will not extend very much laterally through conduction. In most cases the heat will extend 1.5" away from the wires but not more.

Therefore it is import...

Click here to read the rest of this article from Handyman