banner

Floor Heating Systems Installation Excelsior MN

This page provides relevant content and local businesses that can help with your search for information on Floor Heating Systems Installation. You will find informative articles about Floor Heating Systems Installation, including "Electric Radiant Floors". Below you will also find local businesses that may provide the products or services you are looking for. Please scroll down to find the local resources in Excelsior, MN that can help answer your questions about Floor Heating Systems Installation.

Tiger Heating & Air
(952) 942-5748
6724 Kingston Dr
Eden Prairie , MN
 
Abel Onsite
(952) 446-9545
8750 Highway 7
Saint Bonifacius , MN
 
Sabre Heating & Air Cond Inc
(763) 473-2267
3062 Ranchview Ln N
Plymouth , MN
 
Rons Mechanical Inc
(952) 445-8585
12010 Old Brick Yard Rd
Shakopee , MN
 
Southside Heating & A/C Inc
(952) 884-2453
10800 Normandale Bl
Bloomington , MN
 
Classic Heating & Cooling Inc
(952) 448-6323
6250 Chads Ln
Chaska , MN
 
Minnesota Plbg & Htg Inc
(952) 445-4444
1420 W 3rd Ave
Shakopee , MN
 
Elander Mechanical Inc
(952) 445-4692
591 Citation Dr
Shakopee , MN
 
Total Comfort
(763) 383-8383
4000 Winnetka Ave N #100
New Hope , MN
 
Select Mechanical Services Inc
(952) 926-4488
6219 Cambridge St
Saint Louis Park , MN
 

Electric Radiant Floors

You want to look for a product that can be installed in a single layer of thinset cement rather than two layers. This is faster and easier. You also want to find a product where the fiberglass (or other supporting material) forms an umbrella protection over the resistance wire so that your trowel can glide over the fiberglass net without risk of nicking the wire. Some products weave their wire over-and-under a fiberglass net. In that case the resistance wire will always appear on the surface and you face a greater risk of nicking the cable with your trowel ·Thickness of the cold-lead wires that connect the heating rolls to the thermostat: You want the thinnest cold-lead wires available (1/8" thick), so you can easily cover them with thinset cement like the heat resistance wire. If the cold-lead wires are thicker you will need to chisel a grove in the cement slab, or use a circular saw to cut a groove in the plywood sub-floor or backer board to maintain the floor level flat.

· Length of the cold-lead wires: You want cold lead wires that are long enough to connect to the thermostat without additional cut-&-turns of the roll to bring the roll closer to the thermostat.

·Vendor Technical Support Look for a vendor who will design an installation layout customized to your own floor plan. Understand that the heat will not extend very much laterally through conduction. In most cases the heat will extend 1.5" away from the wires but not more.

Therefore it is import...

Click here to read the rest of this article from Handyman