banner

Floor Heating Systems Installation Gautier MS

This page provides relevant content and local businesses that can help with your search for information on Floor Heating Systems Installation. You will find informative articles about Floor Heating Systems Installation, including "Electric Radiant Floors". Below you will also find local businesses that may provide the products or services you are looking for. Please scroll down to find the local resources in Gautier, MS that can help answer your questions about Floor Heating Systems Installation.

Air Masters Mechanical Inc
(228) 497-6462
1820 Old Spanish Trl
Gautier , MS
 
Ball Heating & Air Cond Inc
(228) 392-5432
8332 W Oaklawn Rd
Biloxi , MS
 
Radich Htg A/C & Refg
(228) 392-3773
3232 Quave Rd
Biloxi , MS
 
Modern Htg & A/C
(601) 372-7277
5243 Greenway Dr Ext
Jackson , MS
 
All Pro Heating & Air Inc
(601) 898-3404
303 Red Eagle Cir
Ridgeland , MS
 
Foster A/C & Htg Inc
(228) 497-2285
3416 Suter Rd
Gautier , MS
 
Mike Longo Air Systems
(228) 392-5155
17339 Hwy 67
Biloxi , MS
 
Ace Contractors Inc
(228) 396-5200
13133 Hudson Krohn rRad
Biloxi , MS
 
Gus Hayes A/C & Htg Service
(601) 855-9333
444 Pat Luckett Rd
Canton , MS
 
Adolph Bourdin Inc
(228) 255-3859
9208 Bourdin Dr
Pass Christian , MS
 

Electric Radiant Floors

You want to look for a product that can be installed in a single layer of thinset cement rather than two layers. This is faster and easier. You also want to find a product where the fiberglass (or other supporting material) forms an umbrella protection over the resistance wire so that your trowel can glide over the fiberglass net without risk of nicking the wire. Some products weave their wire over-and-under a fiberglass net. In that case the resistance wire will always appear on the surface and you face a greater risk of nicking the cable with your trowel ·Thickness of the cold-lead wires that connect the heating rolls to the thermostat: You want the thinnest cold-lead wires available (1/8" thick), so you can easily cover them with thinset cement like the heat resistance wire. If the cold-lead wires are thicker you will need to chisel a grove in the cement slab, or use a circular saw to cut a groove in the plywood sub-floor or backer board to maintain the floor level flat.

· Length of the cold-lead wires: You want cold lead wires that are long enough to connect to the thermostat without additional cut-&-turns of the roll to bring the roll closer to the thermostat.

·Vendor Technical Support Look for a vendor who will design an installation layout customized to your own floor plan. Understand that the heat will not extend very much laterally through conduction. In most cases the heat will extend 1.5" away from the wires but not more.

Therefore it is import...

Click here to read the rest of this article from Handyman