banner

Floor Heating Systems Installation Northampton MA

This page provides relevant content and local businesses that can help with your search for information on Floor Heating Systems Installation. You will find informative articles about Floor Heating Systems Installation, including "Electric Radiant Floors". Below you will also find local businesses that may provide the products or services you are looking for. Please scroll down to find the local resources in Northampton, MA that can help answer your questions about Floor Heating Systems Installation.

Pioneer Heating & Cooling Inc
(413) 586-7925
23 Hooker Ave
Northampton , MA
 
CS Heating and Air Conditioning
(413) 323-0254
638 Federal St
Belchertown , MA
 
Dee Service
(413) 789-0800
999 River Rd
Agawam , MA
 
Sandri Energy LLC
(413) 772-2121
400 Chapman St
Greenfield , MA
 
CS Heating and Air Conditioning
(413) 323-0254
638 Federal St
Belchertown , MA
 
Wilson Services Inc
(413) 584-3317
474 Easthampton Rd
Northampton , MA
 
Service Experts Heating & Air Conditioning
(413) 272-2099
8 Capital Dr
West Springfield , MA
 
Deerfield Valley Htg & Clg Inc
(413) 774-7672
301 Wells St
Greenfield , MA
 
The Comfort Man
(508) 477-0594
67 Industrial Dr
Mashpee , MA
 
Mark E Meacham Inc
(508) 248-5551
253a Worcester Rd
Charlton , MA
 

Electric Radiant Floors

You want to look for a product that can be installed in a single layer of thinset cement rather than two layers. This is faster and easier. You also want to find a product where the fiberglass (or other supporting material) forms an umbrella protection over the resistance wire so that your trowel can glide over the fiberglass net without risk of nicking the wire. Some products weave their wire over-and-under a fiberglass net. In that case the resistance wire will always appear on the surface and you face a greater risk of nicking the cable with your trowel ·Thickness of the cold-lead wires that connect the heating rolls to the thermostat: You want the thinnest cold-lead wires available (1/8" thick), so you can easily cover them with thinset cement like the heat resistance wire. If the cold-lead wires are thicker you will need to chisel a grove in the cement slab, or use a circular saw to cut a groove in the plywood sub-floor or backer board to maintain the floor level flat.

· Length of the cold-lead wires: You want cold lead wires that are long enough to connect to the thermostat without additional cut-&-turns of the roll to bring the roll closer to the thermostat.

·Vendor Technical Support Look for a vendor who will design an installation layout customized to your own floor plan. Understand that the heat will not extend very much laterally through conduction. In most cases the heat will extend 1.5" away from the wires but not more.

Therefore it is import...

Click here to read the rest of this article from Handyman