banner

Floor Heating Systems Installation Willimantic CT

This page provides relevant content and local businesses that can help with your search for information on Floor Heating Systems Installation. You will find informative articles about Floor Heating Systems Installation, including "Electric Radiant Floors". Below you will also find local businesses that may provide the products or services you are looking for. Please scroll down to find the local resources in Willimantic, CT that can help answer your questions about Floor Heating Systems Installation.

72 Degrees
(860) 822-1041
43 W Main St
Baltic , CT
 
Nutmeg Mechanical Services
(860) 643-2042
130-3 Utopia Rd
Manchester , CT
 
Aiello Home Services
(860) 292-2600
600 Old County Circle
Windsor Locks , CT
 
Windham County Sht Mtl Svs
(860) 935-5153
Jct Rts 197 & 131 BOX 447
Quinebaug , CT
 
Giordanos Air Cond & Heating
(203) 734-7648
13 Roosevelt Dr
Derby , CT
 
Eastern Refrigeration Co
(860) 537-2385
275 Old Hartford Rd
Colchester , CT
 
Glasco Heating & A/C Inc
(860) 289-5509
56 Glendale Rd
South Windsor , CT
 
Total Refrigeration
(860) 668-1459
770 N Stone St
West Suffield , CT
 
Link Mechanical Services Inc
(860) 826-2212
34 Walnut St
New Britain , CT
 
F F Hitchcock Inc
(203) 272-5400
264 Sandbank Rd
Cheshire , CT
 

Electric Radiant Floors

You want to look for a product that can be installed in a single layer of thinset cement rather than two layers. This is faster and easier. You also want to find a product where the fiberglass (or other supporting material) forms an umbrella protection over the resistance wire so that your trowel can glide over the fiberglass net without risk of nicking the wire. Some products weave their wire over-and-under a fiberglass net. In that case the resistance wire will always appear on the surface and you face a greater risk of nicking the cable with your trowel ·Thickness of the cold-lead wires that connect the heating rolls to the thermostat: You want the thinnest cold-lead wires available (1/8" thick), so you can easily cover them with thinset cement like the heat resistance wire. If the cold-lead wires are thicker you will need to chisel a grove in the cement slab, or use a circular saw to cut a groove in the plywood sub-floor or backer board to maintain the floor level flat.

· Length of the cold-lead wires: You want cold lead wires that are long enough to connect to the thermostat without additional cut-&-turns of the roll to bring the roll closer to the thermostat.

·Vendor Technical Support Look for a vendor who will design an installation layout customized to your own floor plan. Understand that the heat will not extend very much laterally through conduction. In most cases the heat will extend 1.5" away from the wires but not more.

Therefore it is import...

Click here to read the rest of this article from Handyman