banner

Grouting Contractors Washington DC

Looking for Grouting Contractors in Washington? We have compiled a list of businesses and services around Washington that should help you with your search. We hope this page helps you find Grouting Contractors in Washington.

Manganaro Mid Atlantic
(703) 243-0026
1301 N Troy St
Arlington, VA
 
Dawson'S Brickwork
(703) 528-6787
1324 N Stuart St
Arlington, VA
 
Williams John T Assoc Inc
(703) 892-2929
1611 S Walter Reed Dr Ste 102
Arlington, VA
 
A Step In Time Chimney Cleaners & Repair Is 800-Fireman
(703) 237-4545
6700 Lee Hwy
Arlington, VA
 
Boyd D L
(703) 241-2060
6700 Lee Hwy
Arlington, VA
 
Winston'S Air Duct Cleaning Inc
(703) 379-5006
4800 King St
Arlington, VA
 
O Reilly Masonry
(703) 841-7233
5201 5th St N
Arlington, VA
 
Winston'S Of Northern Virginia
(703) 379-5006
2701 S Oakland St Ste C
Arlington, VA
 
R M Thornton Inc
(301) 350-5000
120 West Hampton Avenue
Capitol Heights, MA
Services
mechanical

gt masonry contruction
(240) 723-3632
1911 laguna rd
adelphi, MD
Services
brick,stone,paver,flagstone,block stc
Membership Organizations
gt masonry contruction

HandymanWire -Grout Questions and Answers



How to use a mortar grout bag

I try to lay some paver on my entrance way. And having a big problem on mortar grout bag. No matter what I did(press hard), the mortar seem don't want to come out to fill in the joint. I did put allot of water when mix mortar but still no luck. If you known the trick, please help!!!

There really is no real trick to using a grout bag. Check to make sure that the nozzle is clear or if your bag doesn't have one that you have cut the end of the bag large enough for the grout to pass through. The other thing to remember is don't press the bag twist the top like you are trying to wring it out. Other than that there is not much that can go wrong.

I bought the grout bag from Home Depot, made by plastic with red nose, yes.. it has a little hold with 1/4" diameter. The problem is I used the ready mix mortar also bought from same place for mortar bag, and every time when I try to twist, press.. it doesn't come out and look like all the sand is getting down to the bottom of the bag to block the hold. Can you tell me what part's of the mix technique or the material(mortar and sand) can I use.

Sounds as if the problem is not the bag but the mix. Most spec.mix mortar seems to separate in the bags and if you don't mix hole bags at a time you do not get a good mix. Also and don't ask me why the fine grains of sand always seem to be gone leaving a course and hard to finish mixture. go to your lumber or block yard and buy a bag of Type N or S mortar mix ask them where you can get some plaster sand or you can buy silica sand which is finer yet. Mix the sand and mortar 1 part mortar to 3 parts sand and that should do it.

 

Grouting

I am a ceramic artist. I have made handmade tiles for my kitchen wall and have put them on the wall. The tiles are green/blue with a beige design. I would like to grout the tiles now, but don't want the grout to ...

Click here to read the rest of this article from Handyman