Steam Heaters Longmont CO

This page provides useful content and local businesses that can help with your search for Steam Heaters. You will find helpful, informative articles about Steam Heaters, including "Steam Heat Basics". You will also find local businesses that provide the products or services that you are looking for. Please scroll down to find the local resources in Longmont, CO that will answer all of your questions about Steam Heaters.

Welzig Heating & Air Cond Inc
(303) 678-7728
1831 Boston Ave Suite D
Longmont , CO
Carlson Plumbing & Heating
(303) 776-8074
3 Boston Crt
Longmont , CO
Blue Valley Energy LLC
(303) 993-2645
3075 75th St Unit 1
Boulder , CO
H & M Mechanical LLC
(303) 664-9865
108 E Emma
Lafayette , CO
AHA-Adams Htg & Air Cond
(303) 604-0350
208 Acadia Ave
Lafayette , CO
Climate Masters Service Co
(303) 776-8556
1929 Nelson Rd (9700)
Longmont , CO
Northern Colorado Air Inc
(303) 684-8875
320 Main Street, Suite D
Longmont , CO
Boulder Metal Products Inc
(303) 442-0731
6395 Gunpark Dr Unit C
Boulder , CO
Cory Heating & Air Cond Inc
(303) 237-1011
1130 Linden Ave
Boulder , CO
Schlueter Heating Co LLC
(303) 604-9100
2323 South 120th St
Lafayette , CO

Steam Heat Basics

Operating Pressure

The setting on your boiler for cut in and cut out is controlled by the pressuretrol. The pressure it cuts in at should be set at 1/2 pound (.5 psi) and the pressure it cuts out at should be 1 pound higher at 1 1/2 pounds (1.5 psi). This should be enough pressure to move the steam in your house. If you don't know how to adjust this, have it adjusted by your service tech next time your boiler is tuned up.

If you find that the pressure is adjusted DOWN significantly from where it was to get the .5 to 1.5 operating range, monitor your system's operation. If some radiators are not getting hot, check and replace the main line air vents. The system's pressure may have been raised (erroneously) to compensate for nonworking air vents.

Low pressure is safe. Overpressure is NOT safe.

Low water cutoff

Be sure your boiler has a functioning low water cutoff. Steam systems lose a little bit of water all the time, so there has to be water makeup. Some units have an auto feed, some are done manually. In either case, you want to be sure, the unit will shut off if there is low water. Firing an empty boiler will destroy the boiler and perhaps worse... Check the cutoff regularly and check your boiler's water level weekly

If you have a low water cutoff with a float, flush it at least once a week. This will keep the rust and gook from collecting in it and preventing it from working.

Pipe Insulation

All the piping in the basement leading to from the boiler to the radiators should be insulated. It may have had the old insulation removed in an attempt to get rid of asbestos. But these pipes should be insulated. It will eliminate or reduce the amount of water hammer (that Bang Bang bang) you may be having when the system is fired up. Be sure to use pipe insulation rated for steam piping.

Radiator pitch

Check the radiator with a level. It should be slanted toward the supply pipe. If it is not, raise the vent end with shims to get it level. Sma...

Click here to read the rest of this article from Handyman