Vinyl Flooring Albert Lea MN
Precision Hardwood Floors
414 Ridge Rd
Albert Lea, MN
121 N Broadway Ave
Albert Lea, MN
R & R Flooring
110 N Broadway
402 1st St Sw
Wells Family Dental
150 10th St Se
Home Design Studio
108 West Albert
Root River Hardwoods Incorporated
404 Airport Rd
Albert Lea, MN
301 5th Ave W
19429 Us Highway 218
204 1st St Ne
HandymanWire - Vinyl FLoor Questions and Answers
Removing Vinyl Flooring to Lay Tile
We are trying to replace our vinyl flooring with tile, but are unable to remove the compound beneath the vinyl. The floors been there a really long time. The adhesive remover we bought at Home Depot, mineral spirits, etc. don't work at all.
Did someone tell you that you needed to remove all that compound? I just redid my floor, I had the same condition.. I removed everything that was loose and then tiled on top of everything. It has worked fine with no problems.
The mastic you put down for the tile is thick enough that irregularities are easily covered.
They did tell you to rescrew the floor down, right? Use screws every eight inches along all the joists.
Removing Vinyl Flooring before Laying Tile
Could someone tell me what is the easiest or best way to remove vinyl flooring/glue and all. We're replacing it with ceramic tile and the entire vinyl flooring has been glued down.
Having just done this, I can honestly say.. there is no easy way. Here is what I dealt with. TO have it done professionally, no one would take up the vinyl for fear of asbestos. I didn't want to put anything on top, because I didn't want the extra height.. There are mastics for cementing the tile which can go over the plywood floor, if the the floor is sturdy enough (at least one inch of plywood between the sub floor and the underlayment) So I ripped it up, and scraped it with hand scrapers till I got pretty much everything up. It wasn't easy.. but it only took about one full day to do a 12x38 section of my house.
Linoleum Removal: Tools Needed and Height Added when Replaced w/Tile
I have two layers of linoleum in a small kitchen. I need to replace it with something as it is coming up in some areas and it is ugly!!! What do you think?
I will need a list of tools needed for the job if you think I should remove the linoleum. I read your comments to another person with the same problems and "grunt labor" is nothing I am looking forward to.
Can I only remove what is pulling up? If I leave it on what can I put over it? I was thinking about Ceramic tile. I have looked into it and seems to me that it will raise my floor another inch or more. Is that right? Is that normal and will it look ok around the cabinets and walls?
When I started looking into this.. I was where you are. I tried hiring the job out.. but no one would remove the old vinyl. I think there is too much fear of asbestos.. even though mine was asbestos free. (Yours may not be... if it is older than the 80's.. it probably has it) The pros solution was to cover everything with Luan plywood.. and start over. Well. that was for new vinyl. For tile.. it was another story.
Luan is not good for tile.. besides.. I too, did not like the thoughts of the raised floor. IF your floor is now.. 1 1/8 inches thick.. that is.. you have 1/2-inch subfloor.. and 5/8 inch underlayment.. of plywood.. you can go with tile over that. Ther...
Click here to read the rest of this article from Handyman