Latex or Oil Stain Remover Claremore OK
The Home Depot
9450 N 129th East Ave
1746 South Lynn Riggs Boulevard
M-SA 7 am - 9 pm
SU 8 am - 8 pm
1614 North Lynn Riggs Blvd Claremore, OK, 74017
Cribbets True Value
1008 Main St
LOWE'S OF OWASSO, OK
12001 E. 96TH STREET NORTH OWASSO, OK, 74055
Claremore - Auth Hometown
1648 North Lynn Riggs Blvd
Westlake Ace Hardware
810 N Lynn Riggs Blvd
Pixley Lumber Co
715 W Will Rogers
12001 E. 96Th Street North
M-SA 6 am - 10 pm
SU 8 am - 8 pm
1031 West Highway 20
Stripping Latex or Oil Stains
The only way to ensure a strong adhesion of a new finish to old wood is by getting down to the bare wood. However, years of sealers, old finishes and dirt on an old deck can make a refinishing project seem insurmountable. To cut down on the amount of time you'll have to invest in this project, and to get down to the bare wood quickly, use Flood StainStrip®. It will strip away stubborn coatings like latex or oil-based solid-hide or semi-transparent stains.
| What You Need: |
- StainStrip Exterior Stain Stripper
- Tarp, dropcloths, wiping rags
- Latex gloves, eye protection
- A stiff bristle (not wire) brush
- A standard brush or roller
- Garden hose or pressure washer
- Soap and water
| Doing The Job: |
- Cover any areas you will not be treating or stripping, such as plants, shrubs, bushes and trim work, with a tarp or dropcloth. Be sure to wear gloves and eye protection whenever working with a stain and finish remover.
- With the brush or roller, apply a uniform coat of the undiluted StainStrip remover. Keep the area wet for 15-20 minutes. After 20 minutes, check to see if the old finish is beginning to soften or dissolve from the surface.
- When the dirt and old finish begins to lift from the wood, scrub with the stiff bristle brush or use a pressure washer. Repeat the process on stubborn areas.
- Once the finish is removed, rinse the deck and adjacent areas thoroughly with large amounts of fresh water. Use the highes...
Click here to read the rest of this article from Handyman